Troubleshooting continued, Maintenance log, 12 volt units – Swisher LS728H User Manual
Page 17
17
Problem
Cause
Remedy
Leaking Cylinder
1. Broken seals.
1. See authorized service center.
2. Scored cylinder.
2. See authorized service center.
12 Volt Units
Engine will not turn over
1. Weak or dead battery.
1. Recharge or replace battery.
2. Blown fuse.
2. Replace fuse.
3. Corroded battery terminals.
3. Clean battery terminals.
4. Loose or damaged wiring.
4. Check all wiring.
5. Faulty ignition switch.
5. Check/replace ignition switch.
6. Faulty solenoid.
6. Check/replace solenoid
Engine clicks but will
not start
1. Weak or dead battery.
1. Recharge or replace battery.
2. Corroded battery terminals.
2. Clean battery terminals.
3. Loose or damaged wiring.
3. Check all wiring.
4. Faulty solenoid.
4. Check/replace solenoid.
Battery will not charge
1. Bad battery.
1. Replace battery.
2. Corroded battery terminals.
2. Clean battery terminals.
3. Faulty solenoid.
3. Check/replace solenoid.
4. Bad alternator.
4. See authorized service center.
TROUBLESHOOTING CONTINUED
NOTE: For repairs beyond those listed here, contact your nearest authorized service center.
* Flushing the reservoir tank and hoses with kerosene whenever service is performed on the tank, hydraulic pump or
valve is recommended. Contact an authorized service center.
MAINTENANCE LOG
Notes
Date of Service
Service Performed