Sharp R-22GT - Manual (Page 16)

A31585,R22GV,/22GT/23GT/24GT/25JT
15
CARE AND CLEANING
Door
Wipe the door and window on both sides fre-
quently with a damp cloth to remove any spills or
spatters. Always keep the door seals and seal
surfaces clean so that any grease, spills or spat-
ters are not allowed to build up. Such a build-up
could result in leakage of microwave energy from
the oven.
Air intake filter
Keep the air intake filter clean. Clean at least every
two weeks or more often for heavy use.
Remove the air intake filter by pulling the two (2)
clips on the sides of the filter.
Wash the air intake filter in mild soapy water, rinse
and dry with a soft cloth.
After cleaning re-install the air intake filter.
Hole
Clip
Clip
Air intake filter
Hole
Oven
(B)
Splash cover
Hole
Fig.2
Fig.3 (for R-25JT only)
(C)
(D)
Fig.1
(A)
Splash cover
Door
Oven interior
1) For easy cleaning, wipe any spatters or spills
with a soft damp cloth or sponge at the end of
each day. For heavier spills, use mild soap and
rinse thoroughly with hot water.
2) At least once a week, remove the splash cover
and wash in a mild detergent solution. The
splash cover is located in the top of the oven
and may easily be removed.REMEMBER TO
UNPLUG THE POWER CORD.
Remove two thumb screws (A) as shown in
Fig. 1. Then remove the splash cover from the
oven.
To replace the splash cover, insert two projec-
tions of the cover (B) into the holes of the oven
cavity backplate as shown in Fig. 2. And se-
cure the cover to the oven celing with two
thumb screws (A) as shown in Fig.1.
Special note for R-25JT
The splash cover can be separated into two
pieces for easy cleaning as shown in Fig. 3.
After cleaning, make sure to put (C) in (D) and
replace the splash cover.
3) Wipe any grease, spills or spatters on the door
seal surfaces with a soft damp cloth or sponge
so that they do not build up. The door seals
must always be free of grease and spatters so
that the door closes properly.