Sunfire Speaker - Manual (Page 2)

2
Assembly Guide
Stand Assembly
Tools required:
• Allen wrench supplied
Preliminary steps:
• Run the loudspeaker cables to each location, so these
can be fi tted to the loudspeaker during the assembly
of the stand.
• Unpack your CRM-2 loudspeaker, and get it ready for
use.
• Refer to the CRM-2 owner's manual to determine the
optimum placement of your loudspeakers.
• Alternatively, you can just assemble the column to the
base by following steps 1 through 5 below, and add
the loudspeaker and speaker wires later.
Procedure:
1. Place the column on the fl oor with the top side
face down on the fl oor.
2. Place the stand base onto the column.
3. Make sure the column is locked in the stand
base.
4. Using the four supplied screws, attach the stand
base to the column.
5. Fit the four rubber feet (or spikes) to the base,
and tighten with the supplied wrench.
Column
Base
4 Screws
4 Spikes
6. Feed the speaker wires through the base until
they can be gently pulled through the rectangular
hole near the top of the column.
Wires
Wires
7. Line up the adapter plate with the CRM speaker
making sure the hole on the bottom of the speaker
lines up with the center hole on the adapter plate.
8. Attach the adapter plate to the CRM speaker
using the included Allen head screw.
Allen Screw
Bracket