Sound Performance Lab 9631 - Manual (Page 11)

11
Spectralizer
Control Elements
D ENSITY increases the loudness of the generated harmonics by
applying different “compression ratios”. The control offers six
positions.
Adjustment: If D ENSITY is set to 0, the generated harmonics
have low intensity even at high values for 2 ND and 3 RD
H
ARMONIC
. The increase in high frequencies is mostly created by
the highpass filtering, which applies a shelving equalizing
above the adjusted F
REQUENCY encoder (see F REQUENCY , 3).
Increasing D ENSITY to 1 or 2 will increase audibility of the
generated harmonics. High D ENSITY values (4 to 6) may lead to
audible distortion depending on the source material. Use the
S
OLO function (see 9) to hear the harmonics in isolation.
The LC-display shows all encoder settings.
More information is displayed when activating the I NFO pages
(see 9). Press S TORE and A PPLY for one second to enter the I NFO
pages.
The S OLO function switches the original input off. You will hear
the effect signal only to be able to monitor the highpass-filte-
ring and harmonics generation.
The K ICK function boosts the amplitude of the generated
harmonics in the event of creation (attack-period). After that
the amplitude drops back to its original value. K
ICK should be
used when you want to apply additional “sparkle” and
presence to the signal.
The S PECTRALIZER allows you to store up to 99 presets, which
can be changed by MIDI program change command.
If you want to store a new adjustment, depress S TORE for one
second. The LED starts to flash indicating that the S TORE mode
has been activated. The LC-display now shows the actual preset
number. Use U
P and D OWN to select a new preset location. The
status-LED flashes shortly to indicate that the input (depressing
U
P or D OWN ) is accepted. Keeping U P or D OWN depressed will
let you jump through the preset list in steps of 5 presets. Once a
new preset location is found depress S
TORE again. The S TORE
LED goes out. The preset is stored at the new location.
In case you want to quit the S TORE mode without storing the
new adjustments simply press A PPLY .
Density 7
LC-display 8
Solo 9
Kick 10
Preset 11
Storing a preset:
Depress S
TORE for1 sec.,
LED flashes;
use U
P /D OWN to select
preset no.;
depress S
TORE again,
LED goes out