Samsung ML-3050 - Manual (Page 55)

10.1
<Installing accessories>
10
Installing accessories
Your printer is a full-featured laser printer that has been optimized to
meet most of your printing needs. Recognizing that each user may have
different requirements, however, Samsung makes several accessories
available to enhance the printer’s capabilities.
This chapter includes:
•
Precautions when installing accessories
• Installing a memory DIMM
• Installing a wireless network interface card
Precautions when installing accessories
Disconnect the power cord:
Never remove the control board cover while the power is being supplied.
To avoid the possibility of an electrical shock, always disconnect the
power cord when installing or removing ANY internal or external
accessories.
Discharge static electricity:
The control board and internal accessories (network interface card and
memory DIMM) are sensitive to static electricity. Before installing or
removing an internal accessories, discharge static electricity from your
body by touching something metal, such as the metal back plate on any
device plugged into a grounded power source. If you walk round before
finishing installation, discharge any static electricity once again.
Installing a memory DIMM
Your printer has a dual in-line memory module (DIMM) slot. Use this
DIMM slot to install additional memory.
The ML-3050 has 16 MB of memory which can be expanded to 272 MB.
The ML-3051N and ML-3051ND have 64 MB of memory which can be
expanded to 320 MB.
For order information for optional memory DIMMs, see page 7.1.
1 Turn the printer power off and unplug all cables from the printer.
2 Grasp the control board cover and slide toward you to open it.
3 Completely open the latch on each side of the DIMM slot. Remove
the preinstalled memory DIMM.
4 Take out a new memory DIMM from the plastic bag.
5 Holding the memory DIMM by the edges, align the notches on the
memory DIMM with the grooves on the memory DIMM slot.
1 control board cover
1
1 latch
2 memory DIMM
1
2