Skil 3335-01 - Manual (Page 8)

8.
To avoid injury from unexpected start-
ing or electrical shock, always remove
plug from power source when tool is not in use.
Model 3335-01 Motorized Scroll Saw is shipped com-
plete in one carton.
1. Unpacking and Checking Contents. Separate all
“loose parts” from packing materials and check
each item with the “Table of Loose Parts” to make
sure all items are accounted for before discarding
any packing material.
If any parts are missing, do not
attempt to operate Scroll Saw, plug in
the power cord or turn the switch on until the miss-
ing parts are obtained and are installed correctly.
Table of Loose Parts
Item Description Qty.
A Scroll saw with light attached ..........................1
B Extra pin blade..................................................1
C Allen Wrench (4 mm) ........................................1
D Operating Guide ..............................................1
NOTE: Hardware to mount this Scroll Saw to a bench
or leg set is NOT supplied.
2. If you wish, you may apply a coat of paste wax to
the table to allow the workpiece to slide easily
across the table surface. Wipe the table thorough-
ly with a clean dry cloth.
COMBINATION SQUARE MUST BE TRUE
Check its accuracy as illustrated below.
Unpacking and Checking Contents
Tools Needed
WARNING !
WARNING !
COMBINATION SQUARE
SHOULD BE NO GAP OR OVERLAP WHEN
SQUARE IS FLIPPED OVER IN DOTTED POSITION
DRAW LIGHT LINE
ON BOARD ALONG
THIS EDGE
STRAIGHT EDGE OF
BOARD 3/4"(19mm) THICK-
THIS EDGE MUST BE
PERFECTLY STRAIGHT PHILLIPS SCREWDRIVER
FIG. 1
A
FIG. 2
B
C
D
SM 2610957121 05-08 6/5/08 7:35 AM Page 8