Speakercraft – SpeakerCraft Switch User Manual

Page 2

Advertising
background image

Should you have any questions regarding this, or any other SpeakerCraft product, please call our toll‑free service hotline at
1‑800‑448‑0976. We are available to assist you every weekday, except holidays, between the hours of 7:00 a.m. and 5:00 p.m. PST.

NOTE: When wiring for this configuration
you will need to ignore the "AMP" and "Speak-
er" labels on the terminals. Please instead refer
to the white writing on the circuit board as
illustrated below in (Figure #3).
1. Connect the Amplifiers: Connect the
speaker outputs from the first amplifier or
receiver to the connector that has "A" printed
on the board. Observe proper channel and
polarity of the connections (+ from the ampli-
fier to + input on the control, left channel out
to the "L" side of the connector marked "ampli-
fier" on the selector). Repeat the process for
the other amplifier using the connector "B" as
seen on the board.
2. Connect the Pair of Speakers: Connect
the wires from the speaker pair to one of the
terminals labeled "Common" on the board. Observe proper channel and polarity of the connections (+ from the speaker to + input
on the control, left channel from the speaker to the "L" side of the connector marked "speaker" on the selector).

Mounting the AB-S

(See Figure #4)

Once the selector has been wired it is ready to be mount-
ed into the wall. Referring to diagram #4, place the com-
ponents of the selector into the wall using the enclosed
screws. The AB-S is configured to accept a variety of differ-
ent colored buttons and plates.

Operating the AB-S

Once installed the AB-S provides the ability to select
between two pairs of speakers that are connected to the
same amplifier or between two amplifiers that are con-
nected to the same speaker pair.

Before operating the switch for the first time, turn your
amplifier(s) on (you should have had it off for installation
of the selector). Next, slowly turn up the volume to the
listening level you desire. To make a choice between the
two amplifiers or two speakers, simply depress the button.

Limited Lifetime Warranty

Defective products must be shipped, together with proof of purchase, prepaid insured to the SpeakerCraft Authorized Dealer from whom they were purchased, or to
the SpeakerCraft factory at the address listed on this installation instruction manual. Freight collect shipments will be refused. It is preferable to ship this product in the
original shipping container to lessen the chance of transit damage. In any case, the risk or loss or damage in transit is to be borne by the purchaser. If, upon exami-
nation at the Factory or SpeakerCraft Authorized Dealer, it is determined that the unit was defective in materials or workmanship at any time during this warranty
period, SpeakerCraft or the SpeakerCraft Authorized Dealer will, at its option, repair or replace this product at no additional charge, except as set forth below. If this
model is no longer available and can not be repaired effectively, SpeakerCraft, at its sole option, may replace the unit with a current model of equal or greater value.
In some cases where a new model is substituted, a modification to the mounting surface may be required. If mounting surface modification is required, SpeakerCraft
assumes no responsibility or liability for such modification. All replaced parts and product become the property of SpeakerCraft Inc. Products replaced or repaired
under this warranty will be returned to the original retail purchaser, within a reasonable time, freight prepaid.

This warranty does not include service or parts to repair damage caused by accident, disaster, misuse, abuse, negligence, inadequate packing or shipping proce-
dures, commercial use, voltage inputs in excess of the rated maximum of the unit, or service, repair or modification of the product which has not been authorized
or approved by SpeakerCraft. This warranty also excludes normal cosmetic deterioration caused by environmental conditions. This warranty will be void if the serial
number on the product has been removed, tampered with or defaced.

This warranty is in lieu of all other expressed warranties. If the product is defective in materials or workmanship as warranted above, the purchaser's sole remedy shall
be repair or replacement as provided above. In no event will SpeakerCraft be liable for any incidental or consequential damages arising out of the use or inability to
use the product, even if SpeakerCraft Inc. or a SpeakerCraft Inc. Authorized Dealer has been advised of the possibility of such damages, or for any claim by any other
party. Some states do not allow the exclusion or limitation of consequential damages, so the above limitation and exclusion may not apply.

All implied warranties on the product are limited to the duration of this expressed warranty. Some states do not allow limitation on the length of an implied Warranty.
If the original retail purchaser resides in such a state, this limitation does not apply.

Figure #3

Figure #4

Page 2

AB-S Owner’s Manual

940 Columbia Avenue, Riverside, CA 92507-4492
(800) 448-0976 Fax (909) 787-8747
www.speakercraft.com

LIT20100(rev1)

SpeakerCraft

®

Advertising