Snapper 3250 - Manual (Page 12)

12
Snapper 3250 Watt Generator
TROUBLESHOOTING
Problem Cause Correction
Engine is running, but no AC or
DC output is available.
1. One of the circuit breakers is
open.
2. Fault in generator.
3. Poor connection or defective cord
set.
4. Connected device is bad.
1. Reset circuit breaker.
2. Contact Authorized service facility.
3. Check and repair.
4. Connect another device that is in
good condition.
Engine runs good at no-load but
"bogs down" when loads are
connected.
1. Short circuit in a connected load.
2. Generator is overloaded.
3. Shorted generator circuit.
1. Disconnect shorted electrical load.
2. See "Don't Overload Generator".
3. Contact Authorized service facility.
Engine will not start; or starts and
runs rough. Low oil level. Fill crankcase to proper level or place
generator on level surface.
Engine shuts down when running.
1. Out of gasoline.
2. Low oil level.
1. Fill fuel tank.
2. Fill crankcase to proper level or
place generator on level surface.
Engine lacks power. Load is too high. See "Don't Overload Generator".