Sharp R-1870 User Manual

Page 28

Advertising
background image

26

C L E A N I N G A N D C A R E

FAN

The fan will automatically start when heat rises from
range surface units or burners and when convection,
high mix, low mix or the broil settings are used. This
protects the microwave oven from excessive tempera-
ture rise. The fan will stay on until the temperature
decreases. It cannot be turned off manually during
this time.

For other uses, select either high or low speed.

PRECAUTIONS FOR PROPER USE:

1. DO NOT leave range unattended while using high

temperatures. Automatic fan may start and provide
excessive air to the surface units. This may cause
spattering or boilover.

2. Avoid burning food.

3. Keep grease filters clean.

LIGHT

1. To replace light bulbs, first disconnect power to the

oven at the circuit breaker panel or by unplugging.

2. To release cover remove the screw on the light cover.

(See illustration.)

3. Replace bulbs only with equivalent watt bulbs

available from a Sharp Authorized Servicer or parts
distributor. Bulbs are also available at most hard-
ware stores or lighting centers. DO NOT USE A BULB
LARGER THAN 30 WATTS.

4. Close light cover and secure with screw removed in

step 2.

CAUTION: Light cover may become very hot. Do not
touch glass when light is on. Do not use light for long
time use such as a night light.

Light cover

Screw

Light bulbs

CHARCOAL FILTER

Charcoal Filter, Sharp Part Number RK-220 is used for
No-vented, recirculated installation. The filter should be
changed every 6 to 12 months depending on use.

1. Disconnect power to the oven at the circuit breaker

panel or by unplugging.

2. Remove 3 screws that secure louver.

3. Remove louver by inserting flat edge screwdriver

over each tab depressing the tab down and moving
louver away from unit.

4. Pull the louver away from the oven.

5. Slide Charcoal Filter into position on support tabs.

6. Push louver back into place and gently snap tabs

into place by hand (engaging both the bottom and
top tabs) and replace the 3 screws to secure louver.

OVEN LIGHT

Remove the louver per instructions 1-4 above and
charcoal filter, if used.

5. Slide the light cover forward and lift up.

6. Remove old light bulb and replace only with an

equivalent watt bulb available from a Sharp
Authorized Servicer or parts distributor. Bulbs are
also available at most hardware stores or lighting
centers. DO NOT USE A BULB LARGER THAN
30 WATTS.

7. Replace the oven light cover and charcoal filter, if

used; push louver back in place (engaging both the
bottom and top tabs) and replace the louver
mounting screws.

Louver

Oven light

Charcoal filter

Screw

Screw

Top tab

Bottom tab

Screw

Advertising
This manual is related to the following products: