E. piece inventory d. unpacking – Woodstock W2000 User Manual
Page 6
W2000 Rebel
®
– 5
The Rebel
®
is designed for heavy-duty use, yet it
weighs only 35 pounds and is completely portable.
However, when lifting, we must caution against
improper lifting techniques. Always keep your back
straight and lift with your legs. If you are limited by the
amount of weight you can lift and carry, please refrain
from moving The Rebel
®
until you get the necessary
assistance.
At this time, slide the solid foam packing out. The parts
are arranged in two layers of packing. Remove the
parts in an orderly fashion. This will simplify identifi-
cation and make inventory and assembly that much
easier. When removing the parts, please take care not
to destroy the foam and cardboard carton. It is a good
idea to save the carton for future storage or shipment if
necessary. After you have completed your inventory,
inspect all the parts (especially the contact areas) for
burrs and other irregularities which might hinder the
assembly process. If you find any burrs or flash left
over from the machining or casting process, simply
sand or file them flat. Please note that while this is not
a common occurrence, it is possible that one or more of
the parts could have been missed during the machining
and deburring process.
Carefully remove the items packed in the carton. It
may be a good idea to save the carton and packing
material in case it might be needed in the future. Upon
removal of all items from the package, you should
have:
In the event that any non-propriety parts are missing
(e.g. a bolt or nut etc..) we would be glad to replace it.
For expediency, replacements can be obtained from
your local hardware store.
Figure 1. Rebel
®
parts ready for assembly.
Contents of the bolt bag.
1 Working Table
4 Legs
4 Rubber Feet
2 Short Side Panels
2 Long Side Panels
2 Aluminum Fences
2 Wood Facings
4 Fence Lock Handles
4 T-Nuts (Bagged)
1 Plastic Insert Assembly
1 Starting Pin
1 Safety Guard
1 Safety Guard Bracket
1 Safety Guard Rod
2 Cap screws
1
/
4
- 28 x 1''
1 Miter Gauge
1 Miter Gauge Handle
1 Bolt Bag
Description:
Cap Screws:
Setscrews:
Hex Nuts:
Flat Washers:
Flat Head Screws:
Hex Bolt:
Size:
1
/
4
'' - 28 x
5
/
8
''
1
/
4
'' - 28 x
3
/
4
''
10 - 32 x
3
/
4
''
10 - 32
1
/
4
'' - 20
1
/
4
''
5
/
16
''
1
/
4
'' - 20 x 1
1
/
4
''
5
/
16
'' - 18 x
3
/
4
''
Qty:
20
2
4
4
2
10
1
4
1
E. Piece Inventory
D. Unpacking