Samsung TAD-798 - Manual (Page 15)

15
SCREENING CALLS
To screen calls, let the TAD answer,
then listen to the caller’s message
through the TAD’s speaker. To adjust
the TAD’s volume, slide
VOLUME to-
ward + or – .
If you do not want to take the call, sim-
ply let the TAD finish recording the call-
er’s message.
If you decide to answer the call, pick up
any phone on the same phone line as
the TAD. The TAD stops recording and
resets to answer the next call.
Note: If you pick up the phone just as
the TAD answers, the TAD might not
stop playing the outgoing message. If
this happens, press
STOP .
USING CALL
BREAKTHROUGH
If you screen your calls but want to
know when calls come in from certain
people, give them your call break-
through (CBT) code (preset to 648).
When a caller enters the CBT code dur-
ing the outgoing message, the TAD
alerts you with a series of loud beeps for
35 seconds. To answer the call, pick up
the handset. If you do not answer, the
caller can leave a message after the
outgoing message plays.
Changing the CBT Code
The CBT code is preset to 648, but you
can change it by following these steps.
Note: If you do not complete each step
within 8 seconds, the TAD sounds four
beeps and exits setup. Start again from
Step 1.
1. Hold down CODE ( Co appears) until
the TAD beeps once.
2. Press REPEAT . Cc (CBT code) and
the digits of the current code appear
in sequence, then the first digit re-
appears.
For example, if the CBT code is
648, the message counter shows
Cc , –6 , –4 ,
–8
, then –6 .
3. Repeatedly press SKIP or REPEAT
to set the first digit, then press
STOP . The second digit appears.
43-798.fm Page 15 Monday, August 16, 1999 9:33 AM