Smeg ST115S - Manual (Page 31)

User instructions
30
BEFORE STARTING THE DISHWASHER AFTER PROLONGED
DISUSE:
•
Check that there are no deposits of sludge or rust inside the water
pipe: if there are, allow the water to run from the water supply tap for
a few minutes.
•
Plug the power cord back into the socket.
•
Reconnect the water intake hose and open the tap again.
TROUBLESHOOTING MINOR PROBLEMS
In some cases it is possible to remedy minor problems by referring to the
following instructions:
If the program fails to start, check that:
•
the dishwasher is connected to the electrical power supply;
•
there is no power failure;
•
the water tap is open;
•
the dishwasher door is properly closed.
If water remains inside the dishwasher, check that:
•
the drain hose is not kinked;
•
the drain siphon is not obstructed;
•
the dishwasher filters are not clogged.
If the dishes are not being cleaned properly, check that:
•
the correct amount of detergent has been added;
•
there is regenerating salt inside the special container;
•
the dishes are being loaded correctly;
•
the selected program is suitable for the dish types and their degree
of soiling;
•
all the filters are clean and positioned correctly;
•
the spray arm nozzles are not obstructed;
•
there is no object obstructing the rotation of the spray arms.