Sony DVP-C660 - Manual (Page 58)

58
Settings and Adjustments
x DTS
Selects the DTS signals to be output via the DIGITAL OUT
OPTICAL and COAXIAL connectors. You cannot select
this item when you set “DIGITAL OUT” to “OFF.”
• OFF: when the player is connected to an audio
component lacking a built-in DTS decoder.
• ON: when the player is connected to an audio
component having a built-in DTS decoder.
If the player is connected to an audio component
lacking a built-in DTS decoder, do not set this.
Otherwise, when you play the DTS sound track, a loud
noise or no sound will come out from the speakers,
affecting your ears or causing the speakers to be
damaged.
If you adjust the remote signal, you can control your TV
or AV receiver (amplifier) with the supplied remote.
Default setting is to control Sony TVs with the mark.
Controlling TVs or AV receivers
(amplifiers) with the remote
Hold down TV @/1, and enter your TV’s or AV
receiver’s manufacturer’s code (see the table) using the
number buttons. Then release TV @/1.
Code numbers of controllable TVs or
AV receivers (amplifiers)
If more than one code number is listed, try entering them
one at a time until you find the one that works with your
TV or AV receiver (amplifier).
Notes
• If you enter a new code number, the code number previously
entered will be erased.
• When you replace the batteries of the remote commander, the
code number is reset to 01 (Sony TVs). Reset the appropriate
code number.
Number buttons
TV @/1
Controlling your TV or AV
Receiver (Amplifier) with
the Supplied Remote Z
TV
1
4
7
2
5
8
0
3
6
9
Settings for the Sound (AUDIO SETUP)