Samsung Evergreen a667 - Manual (Page 13)

Getting Started 8
2. Plug the data cable into the base piece provided and into
the Power/Accessory Interface connector on your phone.
3. Plug the base piece into a standard AC wall outlet.
4. When the battery is fully charged, the phone displays a
message telling you the battery is full. Remove the
connector from the phone.
Warning!: If your device has a touch screen display, please note that a touch-
screen responds best to a light touch from the pad of your finger
or a non-metallic stylus. Using excessive force or a metallic object
when pressing on the touch screen may damage the tempered
glass surface and void the warranty. For more information, refer to
“Standard Limited Warranty” on page 135.
Note: Failure to unplug the wall charger before you remove the battery, can
cause damage to the phone.
Low Battery Indicator
When the battery is weak and only a few minutes of talk time
remain, the battery icon (
) blinks and the device sounds a
warning tone at regular intervals. In this condition, your phone
conserves its remaining battery power by reducing the
backlight’s brightness and entering a dimming mode. For a quick
check of your battery level, glance at the battery charge indicator
located in the upper-right corner of your device’s display. Five
bars (
) indicate a full charge.
When the battery level becomes too low, the phone automatically
turns off.
Incorrect
Correct
Correct
DA TA LINK CABLE
Incorrect