Silvercrest KH 2398 - Manual (Page 10)

- 8 -
6. Press the button MEM SET/AMS h once
again to conclude the saving. The display
flashes for 15 seconds, after that the sav-
ing is finalised.
Setting alarm times (Alarm 1–4)
You can programme four alarm times with
your kitchen radio.
Alarm function Symbol in the display o
Acoustic signal
Radio
Switched off no symbol
1. In automatic mode, press one of the
ALARM buttons 1–4 r–u to select the
location for the to be programmed alarm
memory. In the display o the last set
alarm time and the symbol for the type of
alarm blink for 15 seconds.
2. Press the buttons UP  /DOWN  1(/l
to set the desired alarm time.
3. Repeatedly press the ALARM button pre-
viously pressed until the desired alarm
function (see table above) is indicated in
the display o.
4. Repeatedly press the button TIMER g to
set the weekdays on which you require the
alarm function: You can select between
"workdays" (Mo, Tu, We, Th, Fr), "week-
ends" (Su, Sa) and "every day" (Su, Mo,
Tu, We, Th, Fr, Sa). Thereby, orientate
yourself on the weekday indicator in the
display o:
Mo = Monday
Tu = Tuesday
We = Wednesday
Th = Thursday
Fr = Friday
Sa = Saturday
Su = Sunday.
5. If you hold the button TIMER g pressed
down for 2 seconds, you can also,
through repeated brief pressing of the
TIMER g button, select a specific week-
day (e.g. only "We"). The selected setting
is indicated in the display o.
6. To return to the selection of workdays,
weekends or whole weeks, once again
hold the button TIMER g pressed down
for 2 seconds.
7. After 15 seconds the blinking in the dis-
play stops and your input is saved. The ap-
pliance then returns to automatic modus.
When the alarm signal sounds...
• and the alarm function "Radio" has been
selected, the radio plays for one hour at
a pre-defined alarm volume. To exit, press
one of the ALARM buttons 1–4 r–u.
• and the alarm function "Signaltones" has
been selected, the signal tone sounds for
10 minutes, with an increasing volume. To
exit, press one of the ALARM buttons 1–4
r
–u.
Radio operation
For radio reception, completely unwind the
wire aerial e and, with the radio switched
on, determine the most favourable position-
ing for it.
Switching the radio on and off
1. To switch the radio function on, press the
button ON/OFF 2). In the display o the
currently selected frequency is shown.
2. Press the button ON/OFF 2) once again
to switch the radio off and return the ap-
pliance to the automatic modus.
Manual station selection
1. Briefly press the button UP  1( repeat-
edly to search for stations with a higher
frequency than the one shown in the dis-
play o.
2. Briefly press the button DOWN  l
repeatedly to search for stations with a
lower frequency than the one shown in
the display o.
BDA_KH 2398 - DT-49029_6_uk.indd 8 22.06.2010 17:28:47