Smeg STX4-3 - Manual (Page 20)

User instructions
39
CLEANING THE FILTER UNIT
• The central filter H should be inspected regularly and cleaned if necessary. To remove it, take
hold of the handle, turn anti-clockwise and lift.
• Press the central filter H from below to extract it from the micro-filter.
• Separate the two parts of the plastic filter by pressing the body of the filter in the zone shown
by the arrows.
• Remove the central filter by lifting it.
GENERAL WARNINGS AND RECOMMENDATIONS FOR CORRECT MAINTENANCE:
• The filters should be cleaned under running water using a stiff brush.
• It is essential to thoroughly clean the filters according to the above instructions: the
dishwasher cannot function if the filters are clogged.
• Carefully replace the filters in their seats, to avoid damaging the wash pump.
PROLONGED DISUSE:
• Run the soak program twice in succession.
• Unplug the power cord from the socket.
• Leave the door slightly open, in order to prevent the formation of unpleasant odours inside
the washing tank.
• Fill the rinse aid dispenser.
• Shut off the water supply tap.
BEFORE STARTING THE DISHWASHER AFTER PROLONGED DISUSE:
• Check that there are no deposits of sludge or rust inside the water pipe: if there are, allow the
water to run from the water supply tap for a few minutes.
• Plug the power cord back into the socket.
• Reconnect the water intake hose and open the tap again.