Sony ZS-D50 - Manual (Page 25)

The Tape Player
The Tape Player
25 GB
Tips
• If you made a mistake,
press CANCEL. The
track programed last
will be cleared. Re-
program it.
• To check the order of
tracks, press ENTER•
MEMORY CHECK
after step 6 until
“CHECK” appears in
the display. Press
= or + to display
the track number in the
programmed order.
• To check the total
recording time on the
upper side and the
reverse side:
Press DISPLAY before
starting recording.
Each time you press
the button, the display
changes as follows:
“total recording time
on the upper side” n
“total recording time
on the reverse side” n
“total track number
and the tape length
you need to record the
whole CD.
3
Press = or + to select the track you want to
program, and press ENTER•MEMORY CHECK.
Repeat this step.
The total number of
programed tracks and the
minimum tape length
(unit: 2 minutes, up to 98 minutes) you need to
record the programed tracks appear in the display.
Example: The total tape length needed to record
the entire CD is “24” minutes. The maximum
recording time for each side is 12 minutes.
Track Nos.: 1 2 3 4 5 6 7
Length: 05:10 01:20 04:50 02:30 02:30 01:30 04:20
(minutes) Side A (11:20) Side B (10:50)
4
Press ENTER•MEMORY CHECK.
5
To change the recording time, press = or +.
If you do not change the recording time, skip to
step 6.
Example: If you input
“40” minutes for the
recording time, the
maximum recording time
for each side is 20 minutes.
Track Nos.: 1 2 3 4 5 6 7
Length: 05:10 01:20 04:50 02:30 02:30 01:30 04:20
(minutes) Side A (17:50)
Side B (4:20)
6
Press ENTER•MEMORY CHECK.
7
Insert a blank tape into the tape compartment.
8
Press r/P and then (.
Recording will start on the upper side
automatically. The tracks are recorded in the
programed order.
Note
When “--” is displayed
as the tape length, the
total recording time of
the programed tracks
exceeds 98 minutes.
Start from step 1 again.
continued