Fcc regulation – SanDisk Sansa Clip User Manual

Page 26

Advertising
background image

Learn More, Service, and Warranty Information

24

7. Termination. We may terminate this Agreement and the license immediately and
without notice if you breach it. Upon termination of this Agreement, you must delete or

destroy all copies of the Software.

8.

High Risk Activities. The Software is not fault-tolerant and is not designed or

intended for use in hazardous environments requiring fail-safe performance, or any other
application in which the failure of the Software could lead directly to death, personal injury,

or severe physical or property damage (collectively, “High Risk Activities”). SANDISK AND
ITS LICENSORS DISCLAIM ANY EXPRESS OR IMPLIED WARRANTY OF FITNESS FOR HIGH

RISK ACTIVITIES AND SHALL NOT BE LIABLE FOR ANY LIABILITIES OR DAMAGES ARISING
FROM SUCH USE.
9. General. This Agreement contains the entire understanding between the parties with

respect to your use of the Software. If any part of this Agreement is found void and
unenforceable, it will not affect the validity of the balance of this Agreement, which shall

remain valid and enforceable according to its terms. This Agreement is governed by and
construed under the laws of the State of California and controlling U.S. federal law without

regard to conflicts of laws provisions thereof. The U.N. Convention on Contracts for the
International Sale of Goods shall not apply to this Agreement. Any action or proceeding

arising from or relating to this Agreement shall be adjudicated in the state or federal courts
of Santa Clara County, California, and the parties hereby agree to the exclusive jurisdiction
and venue of such courts. You will not remove or export from the United States or re-export

from anywhere any part of the Software or any direct product thereof to any country in
violation of U.S. Export Administration Regulations, or a successor thereto, except in

compliance with and with all licenses and approvals required under applicable export laws
and regulations including, without limitation, those of the U.S. Department of Commerce.

Any waivers or amendments of this Agreement shall be effective only if made in writing and
signed by an authorized representative of each party. You agree that the Licensors are third

party beneficiaries of this Agreement to enforce your performance of the terms and
conditions of this Agreement. The provisions of Sections 2, 3, 4, 5, 6, 7, 8 and 9 shall
survive the termination or expiration of this Agreement.

FCC Regulation

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may

cause undesired operation.


This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause interference to radio or television
reception, which can be determined by turning the equipment off and then on, the user is

encouraged to try to correct the interference by one or more of the following measures:

1. Increase the separation between the equipment and receiver.
2. Correct the equipment to a different outlet so that the equipment and receiver are on

different branch circuits.

3. Consult the dealer or an experienced radio / TV technician for help.

Advertising