Sierra Wireless DART 200 CDPD Modem - Manual (Page 173)

DART 200 CDPD Modem User’s Guide F DART AT Command Set
PN1197-00 Revision 1.0 F-29
Table F-6. Service Provider commands beginning with caret (^) (cont.)
^S Set DART SLIP Address
Sets the SLIP IP Address of the Modem. This internal address is a private address between the modem
and the terminal connected to the serial port and is unknown to the network. This address is often
referred to as being the gateway, router or server address by the TCP/IP stacks that support SLIP
operation.
Since the SLIP address is known only to the terminal and the modem, the convention is to use 1.1.1.2
for this address.
NOTE:
A SLIP address is required to permit the DART to operate in SLIP mode.
Format:
AT^Sn
Where n = the IP address of the modem SLIP port. The format is
nnn.nnn.nnn.nnn.
Result codes:
OK Valid argument
ERROR Invalid argument
NOT ENABLED Modem is not in service provider mode