Soleus Air FCM-30 - Manual (Page 6)

3) Secure the back grill by screwing on the mounting nut. Turn clockwise and tighten
firmly.
4) Loosen the securing screw on the fan blade. Slide the fan blade onto the mounting
shaft with the shaft sleeve facing the motor. Align securing screw with flat groove in
the motor shaft and tighten with Phillips screwdriver.
5) Remove the small securing bolt from the bottom of the front grill. Position front grill
so logo is horizontal and make sure the grill clips are open. Secure the top tab to
the back grill. Fasten the grills together with securing bolt. Hold the front grill
against the rear grill and snap the grill clips closed to complete the assembly.
Converting:
1) On the neck of the fan head, remove the securing knob, carriage bolt and
adjustable tilt knob. Loosen the range of motion screw.
2) Remove the fan head from the old base and slide over the new base so that the
range of motion screw aligns with the range of motion hole.
3) Insert the carriage bolt into the square slot on the fan head neck and push through
the hole.
4) Tighten the range of motion screw. Screw on the securing knob and the adjustable
tilt knob.
6