Woodstock W1099 - Manual (Page 5)

IV. UNPACKING
- 4 - Woodstock Intl., Inc. W1099
Remove the items packed in the carton. It may be
a good idea to save the carton and packing material
in case they might be needed in the future. Upon
removal of all items from the package, you should
have:
1. Dovetail Jig
2. Hand Levers (2)
3. Manual
Figure 1 shows the dovetail jig with handles.
A. HAND LEVERS
The jig is shipped fully assembled except for the
two hand levers. Screw the threaded end of each
hand lever into the clamping rods located on the
top and front of the dovetail jig. Tighten until
secure. Figure 1.
B. MOUNTING
1. Place the jig on your bench top so the front
lap rests against the front of the bench top.
2. Locate the mounting holes in the rear of the
jig. Scribe the hole locations and determine
whether to use nuts and bolts, or lag screws.
Drill the appropriate size holes.
3. Secure the jig to your bench top. Screws can
be tightened by inserting a long screwdriver
through the unthreaded holes in the back of
the jig.
Hint: If you do not wish to permanently devote
bench space to the dovetail jig, mount the jig to a
piece of
3 /
4
" plywood that can be clamped to your
bench top.
V. ASSEMBLY
Dovetail Jig
Hand Lever
Hand Lever