Sceptre Technologies X22 - Manual (Page 34)

Page34 SCEPTRE X22
Troubleshooting
Problem Possible solutions
DISPLAY IS
UNCLEAR AND
UNSTABLE To stabilize and clarify your display, use
the AUTO ADJUST function or change
the resolution to the display’s optimal
setting 1680 X 1050 at 60Hz, then AUTO
ADJUST.
THERE IS NO
LCD DISPLAY
or SCREEN
SAYS NO
VIDEO Make sure you switched to the correct
source. Check both sources to see video
is on the other source. Check your video
cable. It might be corrupt. Swap out the
video cable for another one to see if the
monitor will work. Check your power plug.
See if it is fully plugged in on both the
monitor and the wall.
MONITOR
SAYS “SIGNAL
OUT OF
RANGE” If you have a CRT monitor, please
connect the CRT monitor to the computer
and change the refresh rate down to
60Hz via your video card’s display
settings menu. After the setting of 60Hz
has been change you can then use the
LCD on the computer.
1. To change the setting go to
display settings by right clicking
on your desktop with nothing
selected. Choose the
PROPERTIES option.
2. Click on the SETTINGS tab, then
click on the ADVANCED button.
3. Click on the MONITOR tab and
change the refresh rate to 60Hz.
4. Click on OK 2-3 times to finalize
your change.
If you do NOT have a CRT monitor or it’s
already broken, please make sure both
the X22 monitor and your computer is
turned off.