Sony Blu-Ray Disc/DVD Home theatre System BDV-E280 - Manual (Page 57)

Ad
dit
iona
l Inf
o
rma
tion
57 US
Sound
Tuner
Symptom Problems and solutions
There is no sound. • The speaker cord is not connected securely.
• Check the speaker settings (page 39).
The Super Audio CD sound of a
component that is connected to
the HDMI (IN 1) or HDMI (IN
2) jack is not output. • HDMI (IN 1) and HDMI (IN 2) does not accept an audio format that contains
copy protection. Connect the analog audio output of the component to the
AUDIO (AUDIO IN L/R) jacks of the unit.
There is no sound from the TV
via the HDMI (OUT) jack when
using the Audio Return Channel
function. • Set [Control for HDMI] in [HDMI Settings] of [System Settings] to [On]
(page 51). Also, set [Audio Return Channel] in [HDMI Settings] of [System
Settings] to [Auto] (page 51).
• Make sure that your TV is compatible with the Audio Return Channel function.
• Make sure that an HDMI cable is connected to a jack on your TV that is
compatible with the Audio Return Channel function.
The system does not output
sound correctly when connected
to a set-top box. • Set [Audio Return Channel] in [HDMI Settings] of [System Settings] to [Off]
(page 51).
Severe hum or noise is heard. • Move your TV away from the audio components.
• Clean the disc.
The sound loses stereo effect
when you play a CD. • Select stereo sound by pressing AUDIO (page 34).
The sound comes from the center
speaker only. • Depending on the disc, the sound may come from the center speaker only.
No sound or only a very low-
level sound is heard from the
surround speakers. • Check the speaker connections and settings (pages 14, 39).
• Check the surround setting (page 24).
• Depending on the source, the effect of the surround speakers may be less
noticeable.
• A 2 channel source is being played.
Distortion occurs in the sound of
a connected component. • Reduce the input level for the connected component by setting [Attenuate -
AUDIO] (page 49).
Symptom Problems and solutions
Radio stations cannot be tuned
in. • Check that the antenna (aerial) is connected securely. Adjust the antenna
(aerial) or connect an external antenna (aerial) if necessary.
• The signal strength of the stations is too weak (when tuning in with automatic
tuning). Use manual tuning.