Saturn 2007 Outlook - Manual (Page 396)

How to Add Automatic Transmission
Fluid
Refer to the Maintenance Schedule to determine
what kind of transmission fluid to use. See
Recommended Fluids and Lubricants on page 497.
If the fluid level is low, add only enough of the
proper fluid to bring the level into the crosshatched
area on the dipstick.
1. Remove the dipstick.
2. Using a long-neck funnel, add enough fluid at
the dipstick hole to bring it to the proper level.
It does not take much fluid, generally less
than one half of a pint (0.25 L). Do not overfill.
Notice: Use of the incorrect automatic
transmission fluid may damage your vehicle,
and the damages may not be covered by
your warranty. Always use the automatic
transmission fluid listed in Recommended
Fluids and Lubricants on page 497.
3. After adding fluid, recheck the fluid level as
described under “How to Check Automatic
Transmission Fluid,” earlier in this section.
4. When the correct fluid level is obtained, twist
& lock dipstick cap in place.
Engine Coolant
The cooling system in your vehicle is filled with
DEX-COOL
® engine coolant. This coolant is
designed to remain in your vehicle for five years or
150,000 miles (240 000 km), whichever occurs
first, if you add only DEX-COOL
® extended
life coolant.
The following explains your cooling system and
how to add coolant when it is low. If you have
a problem with engine overheating or if you need
to add coolant to the radiator, see Engine
Overheating on page 400.
A 50/50 mixture of clean, drinkable water and
DEX-COOL
® coolant will:
• Give freezing protection down
to
−
34°F (
−
37°C).
• Give boiling protection up to 265°F (129°C).
• Protect against rust and corrosion.
• Help keep the proper engine temperature.
• Let the warning lights and gages work as they
should.
396