Sony DIRECTV RECEIVER SAT-W60 - Manual (Page 13)

Connecting Your Satellite Receiver
13
Advanced Connection: Connecting Your VCR
VIDEO S VIDEO AUDIO
LINE
IN
LINE
OUT
IN
OUT
VCR
Satellite Receiver
If your TV and VCR have A/V jacks
Connect the VIDEO OUT jacks of your Satellite
Receiver to the A/V input jacks of your VCR
using the supplied A/V cable. Then, connect
the A/V output jacks of your VCR to the A/V
input jacks of your TV using an A/V cable. (Be
sure to match the colors on the jacks with the
colored plugs on the A/V cable.) Some TVs
and VCRs do not have stereo audio, if yours
does not, just connect the white A/V cable to
the Left output jack.
1c
1b
1a
1a
1b
z Tip
To allow your Satellite Receiver to control the
recording functions of your VCR, see page 14.
If your TV and VCR do not have A/V jacks
Connect the VHF(SAT)/UHF OUT jack on the Satellite Receiver to the VHF/UHF input
jack on your VCR using coaxial cable.
Then, connect the VHF/UHF output jack on your VCR to the VHF/UHF input jack on
your TV using a second coaxial cable.
Set the CH3/CH4 switch to the channel that does not carry off-air broadcasts in your
area.
1c
If your TV and VCR have S-Video jacks
Use an S-Video cable instead of the yellow video connection. S-Video cable is
supplied.
Note
With this connection, your input source
is channel 3 or channel 4 depending on
how you set the CH3/CH4 switch on
your VCR.