Sharp PG-A10S - Manual (Page 48)

44
You can use the “Options” menu to enhance the usage for the projector. For operation of the
menu screen, see pages 32 to 35.
Example: “Options” menu screen for
INPUT 2 (S-Video) mode
Lamp Timer (Life)
(Check-
ing the Lamp Life Status)
You can confirm the cumulative lamp usage time
and the remaining lamp life (percentage).
Display the “Options” menu to check the
lamp life status.
Description of Lamp Life
Note
• It is recommended that the lamp be changed
when the remaining lamp life becomes 5%.
For lamp replacement, contact your nearest
Sharp Authorized Projector Dealer or Service
Center.
• The table above indicates rough estimates in the
case of using only in each mode shown. Remain-
ing lamp life changes within the range of the val-
ues shown depending on the frequency at which
“Eco Mode” is switched to “
” (Eco mode) and
“ ” (Standard mode) (see page 45).
Using the “Options” Menu
OSD Display
(Setting On-
screen Display)
This function allows you to turn the on-screen mes-
sages on or off.
Select “ ” (ON) or “ ” (OFF) in “OSD Dis-
play” on the “Options” menu.
Description of “OSD Display” Settings
Remaining lamp life
100% 5%
about
4,500 hours 225 hours
about
3,000 hours 150 hours
Lamp usage condition
Used with only “ ”
(Eco mode) in “Eco
Mode”
Used with only “
”
(Standard mode) in
“Eco Mode”
Selectable settings
ON
OFF
Description
All On-screen Displays are displayed.
INPUT/VOLUME/AV MUTE/FREEZE/
AUTO SYNC/ENLARGE/ “An invalid button
has been pressed.” / “All buttons on
Projector are locked.” are not displayed.
A10X_A10S#E_Print#p40_50.p65 03.2.4, 2:06 PM 44