SMC Networks SMCRPU14 - Manual (Page 27)

2-7
Figure 2-4 Power Receptacle
2. Connect one end of a DC cord to the redundant power receptacle on
the supported switch and the other end to an available receptacle on
the RPU.
3. Repeat steps 1 and 2 for connecting up to four supported switches to
the RPU.
4. Connect one end of the AC cord to the AC receptacle on the RPU,
and the other end to a grounded power outlet.
5. Check the LEDs on the RPU to ensure proper operation. The Link
LEDs for connected switches should light up. If the LEDs indicate
otherwise, see “Troubleshooting” on page A-1 for more information.
100-240V, 50-60Hz 10A