Ardo FL105L - Manual (Page 7)

R
40 °
35 °
30 °
STOP
90 °
75 °
60 °
40 °
30 °
60 °
40 °
30 °
40 ° 30 ° 40 °
30 °
▼ START BUTTON:
After carrying out all operations described at points 1 to 8 of paragraph "WASH CYCLE",
press this button the start the wash cycle.
Once pressed, it will light for about 2-3 seconds to indicate that the program has started.
SM1793
▼ PROGRAMMER KNOB “STOP”:
The stop function resets the washing machine. If, for any reason, you want to change the
wash programme or add more washing to the load during the wash cycle, simply place the
programmer knob in position “STOP” (the button will start to flash). the "START" button
switches off, then set the knob back on the new program required and press "START".
GB
USING THE WASHING MACHINE
▼ VARIABLE SPIN:
The machine offers a wide selection of spin speeds that can be selected beforehand
according to the wash programme. To change the spin speed, simply press button (H) to
select the required speed (fig.1);
if you want to exclude spin, press the button until the spin
phase symbol and "00" only appear on display. (fig. 2).
7
STOP
Warning!! only use this function if strictly necessary and then only if the programme to reset has been
running for a few minutes. Before opening the door after a reset, wait 2 minutes for the locking mechanism
to release.
▼ DISPLAY AND DURATION OF WASH CYCLE:
For each program selected by means of knob (P) the display will show the corresponding
spin speed, the wash phase as well as the duration time of the cycle; such time will decrease
until reaching zero upon program completion. At this point, the word "END" will appear on
display. It is now possible to remove the laundry from the washing machine.
N.B. In the "Cotton" programmes, the duration of the wash cycle indicated on the display at the start
is purely indicative, in that the actual wash time can be influenced by a number of factors such as the
water inlet temperature and pressure and the amount of washing in the drum. During the wash, the
washing machine's electronics will automatically update the time necessary to complete the programmed
cycle on the basis of these factors, thus obtaining the best possible performance in the shortest time.
▼ DELAYED START:
The machine is equipped with a function that delays start of the washing cycle to a maximum
of 16 hours. Every time the button (I) is pressed, the display will show the hours from 1 ....
to 16 that the machine will have to wait until it can start its wash cycle. After pressing
button (L), and once set differed time has passed, the wash cycle will automatically start.
N.B.: The maximum spin speed varies according to the model and is shown on the machine
display. The maximum spin speed that can be selected for each program is the speed that
lights up automatically when selecting a program.
Spin load imbalance control:
This washing machine is equipped with a special electronic control system for correctly
balancing the wash load.
Prior to each spin, the system ensures that the washing is evenly distributed in the drum.If
the washing is not evenly distributed, the final spin speed is reduced, and if the load is very
unbalanced, the spin is not effected.
fig. 1
fig. 2
h. m.
h. m.
h. m.
h. m.