Assembly instructions – Stamina Products 4825 User Manual
Page 9
ASSEMBLY INSTRUCTIONS
STEP 7
Install two AA batteries into the COMPUTER(27). Two batteries are included. See page 15 for detailed
battery installation instructions. Refer to the inset drawing. Run the Connection Wires of the COMPUTER(27)
through the COMPUTER POST(26) from the square hole on the top of the COMPUTER POST(26) until the
Connection Wires extend out of the bottom end of the COMPUTER POST(26). Place the COMPUTER(27)
onto the plate on the COMPUTER POST(26) and secure with ROUND HEAD SCREWS(M5x0.8x15mm)(62).
STEP 8
Connect the SENSOR WIRE(28) and the PULSE PLUG WIRE(37) to the Connection Wires of the
COMPUTER(27), and push the excess wires back into the FRONT FRAME(1). Then insert the COMPUTER
POST(26) into the FRONT FRAME(1) and secure with BUTTON HEAD BOLT(M8x1.25x15mm)(57).
NOTE:
9
STEP 6
NOTE: The RIGHT PEDAL(35) has R stamped on the end of the pedal shaft. The RIGHT PEDAL(35) has
right hand threads and is tightened by turning clockwise. The LEFT PEDAL(34) has L stamped on
the end of the pedal shaft. The LEFT PEDAL(34) has left hand threads and is tightened by turning
counterclockwise.
Thread the RIGHT PEDAL(35) to the right side of the CRANK(7) as shown. Tighten the pedal securely. Do
the same to attach the LEFT PEDAL(34) to the left side of the CRANK(7).
Be careful not to damage the wires when attaching the COMPUTER(27) and the COMPUTER
POST(26).