Samsung Digimax S800 - Manual (Page 35)

ŝ34Ş
Metering Continuous shot
ƈ You can select continuous shot, and AEB (Auto Exposure Bracketing).
- [Single] : Take one picture only
- [Continuous] : Images will be taken continuously
until the shutter button is released.
The shooting capacity depends on
the memory.
- [AEB] : Take three pictures in a series in
different exposures: short exposure
(-0.5EV), standard exposure (0.0EV)
and over exposure (+0.5EV). Use
the mode if it is hard to decide exposure of the object.
ſ High resolution and picture quality increases file saving time, which increases
stand-by time.
ſ If the [Continuous] or [AEB] sub menu is selected, the flash will be off
automatically.
ſ If less than 3 pictures are available in the memory, the AEB shooting is not
available.
ſ It is best to use a tripod for the AEB shooting as the time to save each image
file is longer and the blurring caused by camera shake may occur.
[ PROGRAM mode ]
SHOOTING
Single
Continuous
AEB
ƈ If you cannot obtain suitable exposure conditions, you can change the metering
method to take brighter pictures.
[Multi] : Exposure will be calculated based on an
average of the available light in the image
area. However, the calculation will be
biased towards the centre of the image
area. This is suitable for general use.
[Spot] : Only the rectangular area in the centre of
the LCD monitor will be metered for light.
This is suitable when the subject in the
centre is exposed correctly, regardless of the back lighting.
ſ If the subject is not the centre of the focus area, do not use the spot metering
as this may result in an exposure error. In this circumstance, it is better to use
exposure compensation.
[ PROGRAM mode ]
METERING
Multi
Spot