Sony Bravia KDS-55A3000 - Manual (Page 36)

36
4:3 Default
Select the default screen
mode to use for 4:3
sources Wide Zoom Enlarges the 4:3 picture to fill the 16:9 screen, displaying as much of
the original image as possible.
Normal Displays the 4:3 picture in its original aspect ratio.
Full Enlarges the 4:3 picture horizontally only, to fill the screen.
Zoom Enlarges the picture horizontally and vertically to fill the screen while
maintaining the aspect ratio.
Off Continues using the current Wide Mode setting when the channel or
input is changed.
~
• 4:3 Default is not available when Auto Wide is set to Off.
• If 4:3 Default is set to anything but Off, the Wide Mode setting applies only to the
current channel. When you change channels (or inputs), Wide Mode is automatically
replaced with the 4:3 Default setting for 4:3 sources. To retain the current Wide Mode
setting as channels and inputs are changed, set 4:3 Default to Off.
Display Area +1 Displays the entire picture with a black frame on the edge of the
screen. This setting can be selected for video signals of HDMI input.
Normal Displays the recommended picture area.
-1/-2 Enlarges the picture to hide the edge of the picture.
Screen Position Adjust the Vertical positioning by pressing V/v. Press B/b to adjust the Horizontal
positioning.
~
• The Screen Position feature is useful if the TV is connected to game equipment.
• Screen Position is available only when Wide Mode is set to Zoom.
Vertical Size Adjusts the vertical size of the picture. Press B/b and press to adjust.
~
• Vertical Size is available only when Wide Mode is set to Wide Zoom or Zoom.
~
• It is normal to have a black frame surrounding the picture with all input formats.
Auto Adjust Select Yes to start the auto adjust to display the PC input.
Reset Resets the current screen setting to the default values.
Phase Adjust after Pitch to fine tune overall sharpness.
Pitch Adjust uneven sharpness on screen.
~
• For the PC Input Signal Reference Chart, see page 15.
H Center Allows you to move the position of the picture horizontally (left and right).
To Adjust the H Center
Press
V/v to highlight H Center and press .
Press B/b to correct the centering then press .
V Center Allows you to move the position of the picture vertically (up and down).
To Adjust the V Center
Press
V/v to highlight V Center and press .
Press B/b to correct the centering then press .
Screen settings for PC Timings (HDMI or PC input) differ from all other input modes and are shown below.