Solid State Logic Multichannel Digital Audio Interface MadiXtreme - Manual (Page 47)

Selecting an Input for the Track/Channel Strip
In order to hear an input signal the track input must
be selected. Click the input field near the top of the
track channel strip to display a selection menu. If
you are receiving a stereo test signal via
MadiXtreme inputs 1 and 2, make sure that
1. SSL Soundscape ASIO In (1+2) is selected (as it
should be by default).
Selecting an Output for the Track/Channel Strip
Next, select the track output by clicking the output
field near the bottom of the Track channel strip.
Make sure that 1. SSL Soundscape ASIO Out (1+2)
(Stereo Master) is selected (as it should be by
default).
Note that the output signal is not routed directly to the MadiXtreme outputs 1 and 2. It is routed to the Master section
of the Samplitude Mixer, which itself should be routed to the MadiXtreme outputs 1 and 2.
If you need to change the output routing of the
Master section, click the output field at the bottom
of the Master section, just like you did for the
output of the channel strip, and select the output
pair as required.
Monitoring the Signal
Click the Input Monitoring button to hear the signal going through the channel strip prior
to recording. The track channel strip meters will indicate the signal level, and you will hear
it through your monitoring system. If necessary, adjust the level of your audio source.
Recording
When the signal is passing through the channel, you can record it by clicking the Track Arming button in the track channel
strip, then the Record button in the Transport:
Page 41