Siemens SpeedStream 5450 - Manual (Page 11)

6
Chapter 2
Installation
This chapter covers the physical installation of the router.
Minimum System Requirements
• DSL service and an Internet access account from an Internet Service Provider (ISP).
• Network cables for each device you intend to connect to the router.
• TCP/IP network protocol must be installed on all computers.
Note: Your configuration may vary slightly from the instructions and illustrations in this chapter. Refer to
your service provider’s documentation, or contact them with questions regarding your specific
configuration.
Hardware Installation
You may position the router at any convenient location in your office or home. No special wiring or cooling
requirements are needed; however, you should comply with the safety guidelines specified in the
General
Safety Guidelines section.
Basic Installation Procedure
1. Install line filters if necessar y.
2. Connect the cables .
3. Configure network settings on your computer .
4. Configure the Router via the Web-based management interface .
5. Reboot the computer if prompted. Whenever you are required to reboot the router, allow five seconds
between turning off the unit and powering it back on.
2