Saleen 10-8002-C11790A - Manual (Page 14)

14
VI Front Struts Installation
Part Number Description Qty.
06-1302-B09913* Strut Front Assembly Coupe 2
Figure 1
Figure 2
Order of Operations:
1. With notch facing outside of the
vehicle, slide studs in top of strut into
four upper mounting holes; be sure
the brake line sits behind strut
assembly before tightening the strut
in place. (Figure 1)
2. Use a 13mm deep socket with the
3/8” impact gun to tighten a nut over
each of the four studs (Figure 5, p. 8).
Torque to 26 ft.-lbs.
3. Pull up wheel hub and attach the
bottom of the strut to the knuckle
using stock bolts and nuts. Use the
3/8” impact gun and 18 mm deep
socket to tighten (Figure 2). Torque
to 148 ft-lbs.
4. Put the sway bar end link stud into
rear most hole on strut tower, tighten
using a ½” impact gun with a 18mm
deep socket. (Figure 3) Torque to 85
ft-lbs.
5. Bolt brake line to rear of strut tower
using 10mm socket and 3/8” impact
gun. (Figure 5)
Obtain the following tools:
• ½” impact gun
• 18mm deep socket, ½” drive
• 3/8” impact gun
• 18mm deep socket, 3/8” drive
• ¼” air wrench
• 13 mm deep socket, 1/4”
drive
• 13 mm deep socket, ½” drive
• 10 mm deep socket, ¼” drive
• Ft-Lb torque wrench, ½”
drive
Figure 3
Rear of
vehicle
End
link