Samsung HL-R5687W - Manual (Page 15)

English - 15
Rear Panel Jacks
Use the rear panel jacks to connect components such as a VCR. You can connect different components
such as VCRs, Set-Top Box and a DVD player etc., because there are two sets of video input jacks and
two set of component video input jacks on the rear panel of your TV. For more information, please see
“Connections”.
ΠANTENNA terminals
Two independent cables or antennas can be connected to these terminals.
Use “ANT 1 IN (CABLE)” and “ANT 2 IN (AIR)” terminals to receive a signal from
VHF/UHF antennas or your cable system. (Refer to pages 20~22)
´ Component1, 2 jacks (Y, P B , P R, L, R)
Use these jacks to connect the component video/audio signals from a DVD
player or a set-top box. (Refer to pages 26~27)
ˇ VIDEO/AUDIO OUTPUT jacks
Sends video/audio signal from the TV to an external source, such as a VCR.
These jacks are available only in RF, Video and S-Video modes.
¨ S-VIDEO INPUT jacks
Connects an S-Video signal from an S-VHS VCR or DVD player.
(Refer to page 25)
ˆ VIDEO/AUDIO INPUT jacks
Connect video/audio signals from external sources, such as VCR or DVD players.
(Refer to page 23 and 26)
Ø DVI (Digital Visual Interface) AUDIO INPUT jacks
Connect to the digital audio output jacks of a device with DVI output.
(Refer to page 27)
∏ DIGITAL AUDIO OUT(OPTICAL) jack
Connect to a Digital Audio Component. (Refer to page 29)
” Anynet
Please refer to the Anynet Owner’s Instruction.
This jack is for connecting to other Samsung Anynet-enabled devices.
’ HDMI (High Definition Multimedia Interface)/ DVI
INPUT jack
Connect to the HDMI jack of a device with HDMI output.
Connect to the digital video output jack for device with DVI output.
(Refer to pages 27~28)
˝ CableCARD TM
Insert the CableCARD into the slot. (Refer to page 24)
Ô SERVICE
This jack is for software upgrades.
1_BP68-00448A-02(02~17) 7/6/05 4:39 PM Page 15