Sub-Zero 3 1 5 I - Manual (Page 8)

Dimensions in parentheses are in
millimeters unless otherwise specified.
8
S U B - Z E R O M O D E L S 3 1 5 I A N D 3 1 5 I P I N S T A L L A T I O N
M O D E L 3 1 5 I P D R A I N P U M P
1) Place the ice maker in front of the installa-
tion opening. Adjust leveling legs to the
approximate height.
2) Remove the control knob, control panel and
control access panel.
3) Route the water inlet line ( 1 / 4 " OD copper
tube) from the wall through the ice maker
to the front.
4) Locate the coil of 3 / 8 " ID plastic drain tubing
secured to the back of the unit.
5) Route the plastic drain tube from the back
of the unit to the drain connection point.
IMPORTANT NOTE: Often an air gap is
required by local codes between the ice maker
drain tube and the drain receptacle. Refer to
the illustration below.
6) If the electrical outlet for the ice maker is
behind the unit, plug in the unit.
7) Position the unit in the installation opening.
8) Cut the water inlet line to the required
length.
9) Flush the water line. Place the flare nut on
the water line and flare the end of the
copper tube.
10) Attach the flare nut to the male flare on the
inlet water valve.
11) Turn on the water supply. Make sure that
the ice maker is plugged in and the power
is on.
12) Pour a couple of quarts of water into the ice
storage bin; the drain pump should start
and water should pump out. Check for
leaks.
13) Replace the control knob, control panel and
control access panel. Level the unit as
needed.
IMPORTANT NOTE: All plumbing must meet
local codes.
D R A I N P U M P K I T
This ice maker can be ordered with a drain
pump (Model 315IP) or without (Model 315I).
Models without a pump drain their water by
gravity. However, gravity drain models may
be converted to pump models through the
installation of a drain pump kit.
The parts required for this conversion are
available through your Sub-Zero dealer. You
can also visit the Locator section of our website,
subzero.com, to obtain information on the local
parts distributor and/or dealer in your market.
Detailed installation instructions are included
with the kit.
Drain pump kit (#A36892020)
Drain pump (#12250321)
FRONT VIEW
SHUT-OFF
VALVE
WATER
FILTER
WATER
INLET TUBE
AIR GAP
DEVICE
DRAIN
TUBE
TOP VIEW
SHUT-OFF
VALVE
WATER
FILTER
WATER
INLET TUBE
DRAIN
TUBE
AIR GAP
DEVICE
24"
(609)
1 / 8 " (3)
15 1 / 4 "
(387) MIN.
15 1 / 4 "
(387) MIN.
34 1 / 2 "
(876) NOMINAL
33 3 / 4 "
(857) MIN.
O P T I O N A L
C O M P O N E N T S
Optional installa-
tion components
are available
through your
Sub-Zero dealer.
You can also visit
our website at
subzero.com.
For installation
questions, call
Sub-Zero
Customer Service
at 800-222-7820.
I N S T A L L A T I O N S P E C I F I C A T I O N S
Model 315IP