Samsung SIR-T150 - Manual (Page 7)

CHAPTER ONE
Connecting The Set-Top Box
Rear Panel Jacks
1 1
1.2
ΠRF INPUT (75 Ohm)
Connect the antenna here.
´ RF THROUGHOUT
Connect a coaxial cable between the antenna throughout
terminal on the set-top box and the antenna terminal on
the TV.
ˇ RESOLUTION SELECT
Switches between 1080i (interlaced scanning), 720p
(progressive scanning), 480p (progressive scanning),
and 480i (interlaced scanning) formats. (For HDTV
broadcasts, 1080i is usually the best setting.)
¨ DTV OUT SELECT
(Y, P
B,
P
R
/ R,G,B FORMAT)
Connect to the Y-P
B
-P
R
/RGB digital video input of a digi-
tal-compatible TV set (or the Y-P
B
-P
R
/RBG inputs of some
other video component).
ˆ DOLBY DIGITAL OUT (fiber optic connector)
Connect this terminal to the digital audio input of a TV
set (i.e., to a TV set that has a fiber-optic connector for
digital audio). Or, connect this terminal to the digital-
audio input of a separate component (i.e., AC3-AMP ...).
Ø DTV OUT (R,G,B FORMAT)
Connect to the R, G, B inputs of a TV set, computer moni-
tor, or some other video component.
∏ DTV OUT COMPONENT (Y, P
B
, P
R
format)
Connect to the Y-P
B
-P
R
digital video input of a digital-
compatible TV set (or the Y-P
B
-P
R
inputs of some other
video component).
” Lt/Rt ANALOG-AUDIO OUTPUTS
Connect these terminals to the analog audio inputs of a
TV set (i.e., to a TV that has jacks for L/R inputs).
Or, connect these terminals to the L/R inputs of a sepa-
rate audio component.
’ S-VIDEO OUTPUT
Provides good picture quality. If your TV or monitor has
S-Video capability, use this jack along with the
Audio/Video jacks to connect the Set-Top Box to your
receiver.
˝ VIDEO OUT
If your TV or monitor has Audio/Video capability, con-
nect this jack to the AV Input jack on your TV or monitor
using an Audio/Video cable.
Ô DOLBY DIGITAL OUTPUT (Coaxial)
Connect this terminal to the digital audio input of a TV
set.