Sunrise Medical Quickie Revolution User Manual
Page 15
29
930354 Rev. B
X .
S E T U P & A D J U S T M E N T
Note: Setting the wheelchair on a table or
on a flat surface, such as a table or on a flat
surface, such as a workbench, helps make these
procedures easier.
Note on Torque Setting: A torque setting is
the optimum tightening which should be made
on a particular fastener. A torque wrench
which measures in./lbs. Should be used when
tightening fasteners on Quickie wheelchairs.
Unless otherwise noted, use a torque setting
of 60 in./lbs.When setting up this wheelchair.
A. WHEEL
Depress the quick-release button on the
axle. Slide it into the axle sleeve until it locks.
B. SWING-AWAY ADJUSTABLE
ARMRESTS (OPTIONAL)
1. Installation
a) Slide armrest into receiver on rear
frame tube.
2. Swinging Away
a) Push armrest to the side and out of
the way when transferring.
3. Removing Armrest
a) Pull armrest straight out of bracket.
C. HEIGHT-ADJUSTABLE
ARMRESTS (OPTIONAL)
1. Installation
a) Slide the outer armpost into the receiver
mounted to the wheelchair frame.
b) The armrest will automatically lock
into place.
2. Height Adjustment
a) Rotate release lever to second stop.
b) Slide armrest pad up or down to
desired height.
c) Return lever to locked position
against armpost.
d) Push arm pad until upper armpost
locks firmly into place.
3. Removing Armrest
a) Rotate release lever to first stop and
remove the armrest.
Height-Adjustable
Armrest Key
1. Outer armpost
2. Standard receiver
3. Release lever
4. Armrest pad
5. Transfer bar
6. Side panel
7. Outer armpost tension
adjustment set screws
8. Inner armpost
9. Receiver adjustment bolts
1
6
7
8
4
3
5
9
2
Quick-
Release
Button
B. TO FOLD & UNFOLD CHAIR
Note: You can remove quick-release wheels before you fold chair (and re-mount
them before you unfold chair).
1. To Fold Chair:
a. Move sure footrests are out of the way before you fold chair.
(Swing-away, flip up or remove footrests.)
b. Remove cushion (if any).
c. Grasp center of seat sling and lift sharply until chair folds.
2. To Unfold Chair:
a. Stand to one side of chair. Check to make sure footrests do not interfere.
b. Tilt chair toward you far enough to take the weight off the opposite wheel.
c. Push down on the seat rail closest to you until chair opens fully.
d. Make sure seat rail tubes snap into frame saddles.
I X .
C H A I R B A S I C S
28
930354 Rev. B