Shark SGP-3530E - Manual (Page 17)

97-6132, 97-6151 • REV. 11/04
PRESSURE
W
ASHER
Tr
oub
leshooting Guide
16
97-6132, 97-6151 • REV. 11/04
17
PRESSURE
W
ASHER
Tr
oub
leshooting Guide
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
DETERGENT NOT
DRAWING Air is leaking Tighten all clamps. Check detergent lines for holes.
Injector head may be blocked,
dirty or damaged Clean and make sure ball and spring behind
detergent hose barb or injector body are working
properly.
Filter screen on detergent suction
hose is plugged Clean or replace.
Detergent has high viscosity Dilute detergent to specifications.
Not using soap nozzle Insert soap nozzle into wand coupler.
Detergent level is low Add detergent if needed.
PUMP RUNNING
NORMALLY BUT
PRESSURE LOW
ON INSTALLATION Pump is sucking air Check water supply and possibility of air seepage.
Valves are sticking Check and clean or replace if necessary.
Unloader valve seat is faulty Check and replace if necessary.
Nozzle sized incorrectly Check and replace if necessary (see serial plate for
proper size).
Packing piston is worn Check and replace if necessary.
FLUCTUATING
PRESSURE Valves are worn Check and replace if necessary.
Valve has a blockage Check and replace if necessary.
Pump is sucking air Check water supply and air seepage at joint in suc-
tion line.
Packing piston is worn Check and replace if necessary.
PUMP NOISY Air is in suction line Check water supply and connections on suction
line.
Inlet or discharge valve springs
are weak or broken Check and replace if necessary.
Excessive matter is in valves Check and replace if necessary.
Bearings are worn Check and replace if necessary.
WATER DRIPPING
FROM UNDER
PUMP Piston packing is worn Check and replace if necessary.
O-Ring plunger retainer is worn Check and replace if necessary.
Piston is cracked Check and replace if necessary.
Pump protector is worn Lower water supply pressure. Do not run the spray
gun closed longer than 5 minutes.
OIL DRIPPING Oil seal is worn Check and replace if necessary.
EXCESSIVE
VIBRATION IN
DELIVERY LINE Valves are functioning irregularly Check and replace if necessary.
BURNER MOTOR
WILL NOT RUN Fuel pump has seized Replace fuel pump.
Burner fan loose or misaligned Position correctly and tighten set screw.
There is a loose wire Check and replace or tighten wiring.
Control switch is defective Replace switch.
Burner motor is defective Replace motor.
RELIF VALVE
LEAKS WATER Relief valve is defective Replace or repair relief valve.