Sanyo VHR-H530 - Manual (Page 35)

QUICK TIMER RECORDING (QTR)
As the name suggests, the QTR feature provides a quick
and simple way to set the timer to record. A QTR setting
overrides Program Timer settings.
œ The clock must be set before Quick Timer Recording
can be performed.
œ To set the type of the recording, first follow the steps
under Entering the Program Type on page 26.
œ Start a recording following the instructions for
“RECORDING”, steps
1 – 4 on page 23.
1 Press the REC button during recording.
QTR --:-- will be displayed on-screen.
2 Set the recording end time using the REC button (to
advance the time in 30-minute increments to the
nearest hour or half hour) or the CH/TRACK
l (or j )
button (or CHANNEL on the front panel) (to increase
or decrease the time in 1-minute increments).
Auto Setting
If an XDS-encoded broadcast is being recorded, “Auto”
appears at step
1 above and blinks for 10 seconds
on-screen. The VCR timer received the end time
information from the XDS signal and recording will be
made automatically to end of the program.
Notes on using the AUTO setting
œ To set the recording end time manually, press the REC
button while “Auto” is blinking. The display will switch to
“
--:30 ” or “ --:00 ”. Then use the REC button and/or
the CH/TRACK l (or j ) button to set the recording
end time.
œ Depending on the reception conditions of TV signal or
remaining program duration, the AUTO QTR operation
may not be accurate.
NOTES:
œ The end time can be advanced for a total of up to
24 hours.
œ Recording ends if the end of the tape is reached.
œ To stop recording before the end time is reached, press
the STOP button (or STOP/EJECT on the front panel).
QTR--:--
QTR Auto
SC4HW/NA (VHR-H530 GB) Fri. Jan., 07/2000
34