Star Trac FITNESS E-UBI - Manual (Page 22)

22
620-7991 Rev 002
STEP 12.
Close the center console. Using a #2 Phillips
screwdriver, take the screws retained from earlier
and screw in the (4) screws from below that hold
in the center console. Tighten the screws snug.
STEP 11.
While holding the new center console near the opening of the display, connect the following cables
to there appropriate connector. (There is no particular order):
•
Plug in the (2) DC power cables to the DC connectors, (they are the same so it does not
matter which goes to which).
•
Plug in the PVS remote cable to the PVS remote connector.
•
Plug in the A/V cable to the audio (6-pin) and the video (2-pin) connector, respectively, to the
A/V connectors on the center console board.
•
Take the keypad tail, and the center console ground and feed them through the cable
window.
1
2
4
3
5