Schumacher PI-1500 - Manual (Page 9)

- 8 -
Connecting Your PI-1500
to turn oN:
1. Push the rocker switch, located on the right side, to the
“oN” (I) position. The led indicator light should glow
GReeN verifying the inverter is receiving power and can
deliver power to your device. (A brief audio alarm may
sound or red LED may flash. This is normal.)
2. Turn on the power source or device to be powered.
Note: If more than two devices are to be powered, start
one device at a time to avoid a power surge and overload-
ing the inverter. The surge load of each device should not
exceed 1500 watts.
You can use an extension cord from the inverter to the
device without significantly decreasing the power being
generated by the inverter. For best operating results, the
extension cord should be no longer than 50 feet.
to turn oFF:
1. Push the rocker switch, located on the right side, to the
“oFF” (o) position.
2. Turn off the power source and the device.
3. disconnect inverter from power source and device.
4. Wait for the inverter to be cool to the touch before
disconnecting it from the power source.
Note: The PI-1500 inverter and device should always
be unplugged when not in use.