Sony MHC-RV800D - Manual (Page 62)

62 GB
C MD (VIDEO) IN jacks (VIDEO (MD)
IN jacks for North American model)
Use audio cords (not supplied) to connect the
audio output of the optional component (such
as MD deck or VCR) to these jacks. You can
then output audio through this system.
D MD (VIDEO) OUT jacks (VIDEO
(MD) OUT jacks for North American
model)
Use audio cords (not supplied) to connect the
audio input of the optional component (such as
MD deck or VCR) to these jacks. You can then
make an analog recording from this system.
E SUB WOOFER OUT jack
(MHC-RV900D and RV600D only)
Use speaker cord (not supplied) to connect the
sub woofer speaker.
F DIGITAL OUT jack
Use a digital optical cable (square, not
supplied) to connect the audio input of the
optional digital component to this jack. You
can then record digital audio from this system.
G COMPONENT VIDEO OUT jacks
Use the component cable (not supplied) to
connect the video input of the TV or projector
to these jacks. Make sure to match the color of
the plugs and the connectors.
Listening to audio from a
connected component
Listening to a connected MD
deck
1
Connect the audio cords.
See “Hooking up optional components” on
page 61.
2
Press MD (VIDEO) * .
Start playing the connected component.
Listening to a connected VCR
1
Connect the audio cords.
See “Hooking up optional components” on
page 61.
2
Press MD (VIDEO) * .
Hold down MD (VIDEO)* and press ?/1.
This switches the “MD” function to
“VIDEO”. Once you enable the “VIDEO”
function, just press MD (VIDEO)*.
Notes
• If you cannot select “MD” when you press MD
(VIDEO)*, press ?/1 while holding down MD
(VIDEO)* when the system is on. “VIDEO” will be
switched to “MD”. To return to “VIDEO”, repeat
the same procedure.
• When you connect a VIDEO CD deck, set to “MD”.
• This function is factory-set to “MD” for MHC-
RV900D, RV800D and RV600D, and “VIDEO” for
MHC-GX90D.
* VIDEO (MD) for MHC-GX90D
Hooking up optional components
(continued)