Password – Sharp XG-C40XU User Manual
Page 43
E-42
Useful Features
Password
A password can be set by the user and used with the
keylock level to prevent adjustments to certain settings
on the GUI.
Setting the Password
(Slide the MOUSE/ADJUSTMENT switch
on the remote control to the ADJ. position.)
1 Press MENU.
2 Press ß/© to select “Options”.
3 Press ∂/ƒ to select “Password”, and then press
©
.
4 Enter the new password using ∂/ƒ to select the
desired number, and then press © to select the
next digit. Continue this procedure for the
remaining three digits, and then press ENTER.
5 Enter the password again (“Reconfirm”) using ∂/
ƒ
/ß/©, and then press ENTER.
6 To exit from the GUI, press MENU.
• After setting the password, be sure to write it down in a
secure location so as not to forget it.
Changing the Password
(Slide the MOUSE/ADJUSTMENT switch
on the remote control to the ADJ. position.)
1 Follow steps 1 to 3 in “Setting the Password”
above.
2 Enter the old password using ∂/ƒ/ß/©, and then
press ENTER.
3 Enter the new password using ∂/ƒ/ß/©, and
then press ENTER.
4 Enter the password again (“Reconfirm”) using ∂/
ƒ
/ß/©, and then press ENTER.
2, 3,
4, 5
1, 6
Projector
Remote control
(GUI) On-screen Display
MOUSE
ADJ.
(GUI) On-screen Display
MOUSE
ADJ.
Clearing the Password
If you forget your password, you can use the following
procedure to clear the password.
(Slide the MOUSE/ADJUSTMENT switch
on the remote control to the ADJ. position.)
ON /
/
/
/
/ ENTER /
/
/
/
/ ON /
/
/
/
/ ENTER /
/
/
/
/ ON /
/
/
/
/ ENTER /
/
/
/
/
MENU
• This procedure can be performed either from the projector
or with the remote control.
MOUSE
ADJ.