Southbend HEAVY DUTY COUNTERLINE HDG-48 - Manual (Page 9)

H EAVY D UTY C OUNTERLINE
I
NSTALLATION
O WNER ’ S M ANUAL 1192662 P AGE 9
INSTALLATION
Appliances mounted on a stand with casters or other movable surface must be equipped with a restraining
means to prevent accidental stress on the flexible gas connection.
1. Secure the restraining-device bracket (item “B” in the following illustration) to a wall stud located as
close as possible to the appliance connector inlet and outlet connections. Use four #12 screws (items
“C”) and plastic anchors (items “A”) if necessary.
Figure 3
H
F
I
G
E
D
A
B
C
Note: Kit can be purchased from Southbend (part number 1176867).
2. Install eye-bolt (item “F”) to a frame member on the rear of the appliance. After checking carefully
behind the frame member for adequate clearance, drill a 1/4" hole through the frame member.
3. Thread hex nut (item “G”) and slide the washer (item “H”) onto the eye-bolt. Insert the eye-bolt through
the 1/4" drilled hole and secure with a washer (item “H”) and nylon lock nut (item “I”).
4. Using the spring-loaded snap hooks, attach the restraining device to the bracket and the eye-bolt.
5. Using the cable clamp (item “D”), adjust the restraining device extended length to prevent over-bending
or kinking of the appliance connector.
Note: For units not equipped with flame safety devices, be sure all valves are turned off prior to
disconnecting. After reconnecting, be sure all valves are turned off and all pilots are lit.