Smeg SLB510.1 - Manual (Page 4)

Instructions for Use 6
Removing the Transport Brackets
The washing assembly is blocked with two metal rods which protect
the machine during transport (fig.1).
•
Undo the screws on the rear wall (fig. 2).
•
Remove the squares, rotate them 180
°
and use them to pull out
the rods (fig. 3).
•
Disengaged parts may remain at the bottom since they do not
obstruct the operation of the machine (4 rubber hoses and 4 paper
spools).
•
Use the enclosed plastic caps to plug the holes (fig. 4).
Save the brackets: you may need them later.
3
2
4
1