ScyTek Electronics 100RS - Manual (Page 13)

Astra 100RS - Page 9
+12V or ground only when the parking lights are on and set the internal parking light relay
jumper to the proper polarity. For parking light circuits exceeding 10 amps, a relay is required.
For vehicle’s with independent left and right parking light circuits, diodes must be installed to
keep the circuits separate. NOTE: Do not connect the WHITE wire to the vehicle’s headlight
circuit.
Pin 16 RED WIRE: Module Power Input (+). Connect to a constant source of +12V.
2-Pin Blue Connector: Valet switch port. Mount switch where it is accessible from the driver’s
position.
2-Pin Red Connector: LED port. Mount LED where it may be easily seen from either side of the
vehicle.
3-Pin White Connector: Not used.
5-Pin White Flat Connector: Antenna connector port.
Starter doesn’t start and Parking Lights flash:
3 Times - Hood Trigger is active
4 Times - Brake Lights stay On
5 Times - Unit is in Valet (service) mode, and start is disabled.
6 Times - Handbrake Off (Manual Transmission Mode Only).
7 Times - Start sequence not initiated (Manual Transmission Mode Only).
Starter Diagnostics