Smart Technologies SMART UF75 - Manual (Page 6)

6 | KNOWLEDGE BASE – MAINTAINING YOUR SMART UF75 PROJECTOR
NOTE
You should be able to place the lamp module into the projector easily without
applying much force.
4. Use the Phillips screwdriver to tighten the captive screws.
5. Carefully replace the lamp cover.
6. Connect the power cable.
7. Press the Power button once on the remote control or the ECP to confirm that the
projector is operating and that the lamp module is correctly installed.
To complete the projector
lamp installation
1. Turn on the projector.
2. Adjust the projector image if necessary.
3. Access the service menu to reset the lamp hour counter. See Resetting the lamp
timer in your SMART Board interactive whiteboard system user’s guide
(
smarttech.com/support ).
4. Activate the projector’s alert e-mails and lamp warnings if they’ve been
deactivated. See the appropriate sections in your SMART Board interactive
whiteboard system user’s guide (
smarttech.com/support ).
Installing and removing the filter
For optimum performance, replace the projector filter every 12 months. Increase this
frequency according to environmental conditions.
To install the filter 1. Place the filter on left side of the projector.
2. Push gently on the filter until the tabs click into place.