Symbol Technologies LS 1000 - Manual (Page 67)

4-33
LS 1000 Product Reference Guide: Chapter 4, Programming the LS 1004
Data Format
This parameter sets the transmit data format. The options are:
• 7 Data Bits (With Parity) (default)
• 8 Data Bits (With Parity)
• 8 Data Bits (Without Parity)
Stop Bit Select
The stop bit(s) at the end of each transmitted character marks the end of transmission
of one character and prepares the receiving device for the next character in the serial
data stream. The number of stop bits (one or two) selected depends on the number the
receiving terminal is programmed to accommodate. Set the number of stop bits to
match host device requirements.
Check Parity
This option determines whether the parity of received characters is checked. The type
of parity used is selectable through the PARITY parameter.
7-Bit 8-Bit
1 STOP BIT 2 STOP BITS
Check Parity of Re-
ceive Data Enable
Check Parity of Re-
ceive Data Disable
coverBook Page 33 Monday, December 1, 1997 2:19 PM