Technical specifications – Shark EP600 User Manual

Page 4

Advertising
background image

GETTING TO KNOW YOUR SHARK TURBO STICK VAC

OPERATING INSTRUCTIONS cont.

2

Technical Specifications

Voltage:

120V., 60Hz.

Power:

7.5 Amps, 900 Watts

• Hold the dust cup in your hand.

• Make sure that the slot on the bottom

of the cup is pointed in the same

direction as the pins in the unit (see

drawing #1).

• Slide the dust cup inside to the end of

its place in the unit (see drawing #2).

• Turn the dust cup 90° in the direction

shown in the drawing (#3) at right.

• The unit is now ready to be used

again.

Note:

To keep the vacuum cleaner

looking new, it can be wiped with a damp
cloth and a mild soap solution, then
thoroughly dried. Never use any type of
chemical cleaners as they can damage
the vacuum cleaner. When not in use,
store the vacuum cleaner in a dry, clean
place.

Warning:

After extended use, the body

of the vacuum cleaner may become hot.
When using the unit with the shoulder
strap, the unit will touch the body of the
user. Therefore make sure to use the
vacuum cleaner with the strap only when
the unit is cool. If it gets too warm, allow it
to cool before continuing to use it.

Motor Thermostat

Hook for

Shoulder

Strap

Hook for

Shoulder Strap

IMPORTANT:

This unit is equipped

with a motor protective thermostat. If

for some reason the vacuum cleaner

should overheat, the thermostat will

automatically turn the unit off. Should

this occur:

• Push the On/Off button once.

• Disconnect the plug from the

power source.

• Check the source of overheating

problem. (i.e. clogged hose or

filter).

• If clogged hose or filter is found,

unclog the hose and replace the

filters.

• Wait at least 45 minutes before

attempting to reuse the vacuum.

• After unit has cooled down for

45 minutes, plug in the cleaner

and push the On/Off button. The

vacuum should start again.

• If the vacuum still does not start,

contact customer service at

1-800-798-7398.

Replacing The Dust Cup Into The
Unit

Attaching the Shoulder Strap

Use the hooks to attach the shoulder

strap to the vacuum cleaner.
Connect the dog leash swivel hooks

to the eyelets located near the top of

the unit handle and at the base of the

unit. Adjust the strap as required for

comfort.

7

Advertising